|
|
Synths |
| Last Updated: | |
| KORG 700S (Mini-Korg K-2) | |
| W I R I N G | |
| | Front Panel | PCB Boards| Trimmers | 700S Side Panel | | |
Heavy Graphics!!
| Korg 700S Wiring / Internal Shots | ||||
|
These are photos I took from the internals
of one of my Korg 700S (the 2nd one to be exact),
showing which wire is connected where, in case any has gotten loose or
needed a quick check. |
||||
| THE FRONT SLIDERS/SWITCHES/ROTARY'S | ||||
| Shots were mostly taken facing from the rear of the synth, so I can get most of wire/connections into the photos. | ||||
| [Click to Enlarge] | ||||
|
|
From Left to Right: The Pitch/Tune Slider & Power Switch |
|||
|
|
From Left to Right: The 4 Sliders - Portamento, Vibrato Depth / Speed, Repeat Rate |
|||
|
|
From Left to Right: The Switches - Portamento, Delay Vibrato, Vibrato, Repeat, Bender, Sustain |
|||
|
|
From Left to Right: (Vibrato), Repeat, Bender, Sustain, Bright, Expand |
|||
|
|
From Left to Right: Bright, Expand, then the MODE (Waveform) Selector |
|||
|
||||
| Detailed shots on the Mode Rotary Selector: | ||||
|
|
||||
|
|
|
|
|
|
|
These 2 taken from the Front |
|
|
|
|
|
||||
|
From Mode Rotary to the Octave Rotary: |
||||
|
|
|
|
|
|
|
||||
|
|
From Left to Right: Percussion, Attack, then "HIGH" side of Traveler Sliders |
|||
|
|
From Left to Right: The 2 Traveler sliders, Volume slider on far right. |
|||
|
|
Volume slider facing from Front. | |||
|
|
The Power Transformer. | |||
|
|
The Lo / Hi Output jack sockets. | |||
|
||||
| THE PCBs / The "Pads" | ||||
| [Click to Enlarge] | ||||
| The PSU board on the left... | ||||
| The board in the middle... | ||||
|
|
|
|
||
|
|
|
|
||
|
The board on the right... |
||||
|
|
|
|
||
|
The 700S Ring-Mod Board... |
||||
|
|
|
|
||
|
| THE TRIMMERS | ||
| [Click to Enlarge] | ||
| The Trimmers... | ||
|
| The 700S Ring-Mod Side Panel Switches and Sliders | |||
| [Click to Enlarge] | |||
|
July 2005 |
|||
![]()